Ten-Tec SSB-CW-AM Instruction Manual page 54

1/4-watt resistors, cont.
3-48. Resistor R18, 4.7K (yellow-violet-red).
3-49. Resistor R19, also 4.7K.
3-50a. Resistor R29, 10K, (brown-black-orange).
3-50b. Resistor R30, also 10K.
3-51. Resistor R32, also 10K.
3-52. Resistor R38, also 10K.
3-53. Resistor R15, 15K, (brown-green-orange).
3-54. Resistor R23, 22K (red-red-orange).
3-55. Resistor R39, 47K (yellow-violet-orange).
3-56. Install inductor
3-57. Install inductor
3-58. Install C9, the large mylar film
(marked 474).
3-59. Install C10, the mylar film
473).
3-60. Install capacitor C12, also mylar film
3-61. Install C11, .01 pF mylar film (marked 103). [Be sure
to use a film type capacitor, not ceramic disc for C11.]
3-62. Install electrolytic capacitor
(+ ) polarization as outlined on the board.
3-63. Install electrolytic capacitor
3-64. Install electrolytic capacitor
Install the following disc ceramic capacitors:
3-65. Capacitor C23, 3 pF.
3-66. Capacitor C24, 10 pF.
3-67. Capacitor C19, 27 pF.
3-68. Capacitor C21, 33 pF.
3-69. Capacitor C22, 33 pF.
3-70. reserved
3-71. Capacitor
3-72. Capacitor
3-73. Install "0 ohm" jumper JMP3.
3-74. Read entire text before soldering: Solder a 1/2" length
of bare wire (trimmed from a part already installed) to the pad
marked "VCO TP" near 019. This is the VCO Test Point to
(red-violet-silver-gold).
(orange-white-silver-gold).
{marked 102).
(marked 103).
1254 - Assembly - 33
capacitor
capacitor (marked
, with correct
, per step 3-62.
, per step 3-62.