Table Of Contents - Viessmann VITODENS 222-F Service Instructions Manual

Table of Contents

Safety
General Information
Start-up
Service
4
Vitodens 222-F B2TA 19 and 35 Service
Safety, Installation and Warranty Requirements..............2
Product documentation..........................................2
Warranty..............................................................2
Licensed professional heating contractor..................2
Advice to owner....................................................2
Operating and Service Documentation......................2
Carbon monoxide...................................................2
Fresh air..............................................................2
Equipment venting.................................................2
Fiberglass wool and ceramic fiber materials..............3
First aid measures..................................................3
About the Installation Instructions.................................3
Necessary Tools.........................................................6
Important Regulatory and Installation Requirements........6
Codes..................................................................6
Technical literature................................................6
Initial start-up.......................................................6
Working on the equipment.....................................6
Instructing the system user....................................6
Applicability..............................................................8
Product Information....................................................8
Mechanical Room......................................................9
Overview.................................................................10
Removing the Front Panels.........................................11
Accessing the User Interface Programming Unit............11
Select Language.......................................................12
Set Time and Date....................................................12
Filling Siphon With Water...........................................12
Filling the Heating System..........................................13
Bleed (Vent) Air from Boiler Heat Exchanger.................14
Bleed (Vent) Air from Heating System.........................14
Check Power Supply Connection.................................15
Designating Heating Circuits.......................................15
Select Gas Type.......................................................15
Convert Fuel Type to Liquid Propane Gas.....................16
Setting Altitude Parameters........................................16
Checking the Static and Supply Pressure.....................17
Sequence of Operation and Potential Faults During
Each Start-up Cycles.................................................18
Set Maximum Output................................................19
Check All Primary and Secondary Circuit
Connections for Leaks...............................................19
Perform Combustion Analysis.....................................19
Checking the Burner Flue Gas Flapper..........................20
Checking the Balanced Flue System Tightness
(Annular Gap Check).................................................20
Remove Burner Assembly...........................................20
Checking the Burner Gasket and Burner Gauze
Assembly................................................................21
Check and Adjust Ignition and Ionization Electrodes......21
Cleaning the Heat Exchanger and Fitting the Burner......22
Page