Viessmann VITODENS 222-F Service Instructions Manual page 30

Outdoor Reset Programming Unit
Menu
(continued)
Legend
A Dialogue line
30
Vitodens 222-F B2TA 19 and 35 Service
Note: For any other connected heating circuits, use the
settings in the extended menu.
Call up the standard menu as follows:
- If the screen saver is active
(see extended menu below)
- Press any key except
If you are somewhere in the menu:
Keep pressing until the standard menu appears.
Symbols on the display
These symbols are not always displayed, but appear
subject to the system version and the operating state.
Heating programs
Standby mode with frost protection monitoring
9
Only DHW
w
Heating and DHW
wz
Displays
HC1 (2, 3) To display the heating circuit selected in the
standard menu
To change this, see operating instructions
Frost protection monitoring
e
Central heating with standard temperature
s
Central heating with reduced temperature
m
Party mode enabled
Economy mode enabled
Messages
Service message
Fault message
Extended menu
In the extended menu, you can adjust and scan the
settings from the control unit's range of functions used
less frequently, (e.g. time programs and holiday programs).
The menu overview can be found on page 66.
Call up the extended menu
If the screen saver is active:
?
Press any key except , and then press
If you are somewhere in the menu:
Press .
How to use the controls
The screen saver will become active if you have not
adjusted any settings on the programming unit for a
few minutes. The display brightness is reduced.
?
.
.