Lubrication - Ferris IS5100Z Series Operator's Manual

LUBRICATION

Lubricate the unit at the locations shown in Figure 20
through 24.
Grease:
Use grease fittings when present. Disassemble
parts to apply grease to moving parts when
grease fittings are not installed.
Not all greases are compatible. Ferris Red Grease
(P/N 5022285) is recommended, automotive-type
high-temperature, lithium grease may be used when
this is not available.
Figure 20. Deck Lift Linkage Pivots
Figure 21. Deck Lubrication
Lubricating the Front Casters
Maintenance Interval: Annually
1. Remove the 1/4-28 bolt (A, Figure 24) screwed
into the caster and install a 1/4-28 grease fitting.
2. Grease the front caster.
3. Remove the 1/4-28 grease fitting and reinstall the
1/4-28 bolt.
4. Repeat the process for the other side side of the
machine.
Regular Maintenance
Oil:
Generally, all moving metal parts should be oiled
where contact is made with other parts. Keep oil
and grease off belts and pulleys. Remember to
wipe fittings and surfaces clean both before and
after lubrication.
Figure 22. Control Handle Pivots & Seat Pivots
Figure 23. Gearbox Drive Idler Pivot
Figure 24. Front Caster & Wheel
A. 1/4-28 Bolt
A
33