Ferris IS5100Z Series Operator's Manual page 19

Is5100z series zero-turn riding mower
Hide thumbs Also See for IS5100Z Series:
Table of Contents

Advertisement

PTO (Power Take Off) Switch
The PTO switch engages and disengages the mower.
Pull UP on the switch to engage the mower, and push
DOWN to disengage the mower.
Throttle Control
Moving the throttle control fully forward is FULL
throttle position. Always operate the unit at FULL
throttle when mowing.
Parking Brake
DISENGAGE
Releases the parking brake.
ENGAGE
Locks the parking brake.
Pull the parking brake lever back to engage the
parking brake. Move the lever fully forward to
disengage the parking brake. NOTE: To start the unit
the parking brake must be engaged.
Deck Lift Pedal, Cutting
Height Adjustment Pin & Deck Lift Lock
Lever
These control the cutting height of the mower deck.
Depress the pedal until it locks into the 6" (15,2 cm)
position. Place the adjustment pin in the desired
cutting height and release the lift lock lever.
Hour Meter / Maintenance Reminder
Measures the time of the PTO being engaged. The
hour meter measures the number of hours the PTO
has been engaged. The hour meter will flash an
initial oil change indicator at 5 hours, and a lubrication
reminder every 50 hours. These reminders display
for approximately two hours and will automatically
reset themselves.
Note: The hour meter will register the passage of time
only when the PTO is engaged. The hour meter has
a self contained power source so the total hours are
always visible.
Features & Controls
Glow Plug Indicator
Lamp that indicates that the glow plugs are heating.
Hold the ignition key in the "HEAT" position until
indicator lamp turns off, then turn the key to start.
Voltage Gauge
Gauge measures the output voltage of the engine
charging system.
Oil Pressure Indicator
Lamp that indicates a low oil pressure condition. If
the indicator lamp is ON, it will turn the PTO OFF.
Water Temperature Gauge & Indicator
Gauge measures the engine coolant temperature.
Lamp that indicates a high coolant temperature. If
the indicator lamp is ON, it will turn the PTO OFF.
Fuel Tank Cap
To remove the cap, turn counterclockwise.
Fuel Level Gauge
Displays the fuel level in the tank.
Power Outlet
Unit is equipped with a +12VDC, 20A power outlet.
17

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents