Advertisement
3.3 MOD-16P,
3
1.
LCD display:
2.
CH-ON Key:
switch ON and OFF. Once you have switched the unit ON, just press this
key again slightly and you can edit various parameters such as CHANNEL,
GROUP , RF POWER LEVEL and LOCK/UNLOCK. Once you are in the LOCK
position no further operation is allowed and, in a few seconds, the display
will show the current channel selected (0 to 99). Battery level will also be
shown.
3.
SELECT key:
edit certain parameters. Press this key for a few seconds and the unit
will enter in the MUTE mode. (In this way, you can tell your Bass Player
what you think about the Sound Engineer without everybody knowing that!).
Press it again for a few seconds and you will unmute the unit.
4 Mini 4P Connector: This connector is used to connect the unit with the
clip microphones, for example, HM-38 condenser microphone or LM-10
clip microphone.
1
5
Charge Jack: With the rechargeable batteries put inside, use the charger
supplied in your system to recharge the batteries.
6
Battery Compartment: This unit may be powered from one pair dry or
rechargeable batteries, UM3 size AA 1.5V.
Body Pack
Transmitter
1
2
This nice blue LCD will indicate the current operation status.
If you press this key for a few seconds your Transmitter will
Once you are in operation mode you can access this key to
4
3
Pin 1, for guitar, bass and keyboards
Pin 2, GND
Pin 3, Phantom power supply for Condenser microphone
Pin 4, for Dynamic or Condenser microphone
2
4
5
7
7
6
8
Advertisement
