Diamondback 910Ef Owner's Manual page 45

Classic Program Selec on
From the Idle mode, press the QuickSet Program key to open the desired category. The fi rst available course profi le will post in
the Display Matrix. Use the UP and DOWN arrow keys to view all course profi les. Press the ENTER key to select the displayed
profi le and launch the Classic Programs Setup Mode.
Classic Programs Setup Mode
Once a Classic Program has been selected, on-screen messaging will guide the user throughout the Setup Mode.
NOTE: The user may press the GO key at any me during the Setup mode to bypass the setup and begin the workout im
mediately the with previously-saved default values. Note that the heart rate feedback will only be accurate if values
for the selected profi le are correct for the current use.
User Selec on
"Select user" will post in the Lower Display. "User 1" or the previously-entered User 1 name value will scroll in the Matrix
Display. Use the UP and DOWN arrow keys to view the user selec on op ons ("User 1", "User 2" or "Guest"). When the desired
user profi le is displayed, press the ENTER key to select. Guest user will run with default data and will not operate all heart rate
func ons. If the User Setup steps for the selected profi le have not been completed, the console will launch the User Setup mode
(see the sec on tled User Setup Mode for more informa on), otherwise, the program will launch immediately.
Classic Programs Launch Mode
Once the Classic programs have launched:
• The Matrix Display will post the workout profi le and the current progress in the program will be indicated by a fl ashing stack
of segments. The height of the stacks represents the level of resistance; the higher the stack, the greater the resistance. The
resistance may be adjusted manually via the UP and DOWN arrow keys.
• The Level display will indicate the current resistance level. The range is from 1 to 32.
910Ef Owner's Manu
43
al
PROGRAMS