Table of Contents
Advertisement
Electrical Safety
The electric motor has been designed for one voltage range only. Always check that
the power supply corresponds to the voltage on the rating plate. 220–240 V AC
means your tool will operate on alternating current. Operation at a voltage outside this
range can cause loss of power and can result in overheating. All D
factory tested; if this tool does not operate, check the power supply. Your D
tool is double insulated, therefore no earth wire is required.
• Young children and the infirm. This appliance is not intended for use by young
children or infirm persons without supervision.
– This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
– Children should be supervised to ensure that they do not play with the appliance.
• Replacement of the supply cord. If the supply cord or plug is damaged, it must
be replaced by the manufacturer or an authorised D
order to avoid a hazard.
Extension Cords
CAUTION: Use only extension cords that are approved by the country's Electrical
Authority. Before using extension cords, inspect them for loose or exposed wires,
damaged insulation and defective fittings. Replace the cord if necessary.
Specific Safety Rules for Worklights
WARNING: Fire hazard. Do not operate worklight near flammable liquids or in
gaseous or explosive atmospheres. Internal sparks may ignite fumes causing personal
injury.
• Do not expose light to wet or damp areas. Do not expose light to rain or snow.
• Do not wash light with water or allow water to get inside light. Do not submerge
light in water at any time.
WARNING: DO NOT PLACE THE WORKLIGHT IN A POSITION WHICH MAY CAUSE
ANYONE TO intentionally or unintentionally stare into the light. Serious eye injury
could result.
CAUTION: When not in use, place light on its side on a stable surface where it
will not cause a tripping or falling hazard. Some products with large battery packs
will stand upright on the battery pack but may be easily knocked over.
WARNING: We recommend the use of a residual current device with a residual
WALT tools are
current rating of 30mA or less.
E
WALT
E
• The label on your light may include the following symbols. The symbols and their
definitions are as follows:
V ................. volts
Hz ............... hertz
min ............. minutes
...................
...................
...................
WALT Service Centre in
E
.../min ........ per minute
IPM ............. impacts per minute
SPM ............ strokes per minute
SAVE ALL WARNINGS AND INSTRUCTIONS FOR
Important Safety Instructions for All Battery Packs
When ordering replacement battery packs, be sure to include the catalog number and
voltage. Consult the chart at the end of this manual for compatibility of chargers and
battery packs.
The battery pack is not fully charged out of the carton. Before using the battery pack
and charger, read the safety instructions below and then follow charging procedures
outlined.
• Do not charge or use the battery pack in explosive atmospheres, such as in the
presence of flammable liquids, gases or dust. Inserting or removing the battery
pack from the charger may ignite the dust or fumes.
3
A ...............amperes
W ..............watts
........ direct current
n o ..............no load speed
.............. Class I Construction
(grounded)
n ................rated speed
.............. Class II Construction
(double insulated)
BPM ..........beats per minute
RPM ..........revolutions per minute
sfpm ..........surface feet per minute
FUTURE REFERENCE
READ ALL INSTRUCTIONS
...........alternating current
...........alternating or direct current
.............earthing terminal
..............safety alert symbol
Advertisement
Table of Contents
