Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for DeWalt XR Li-Ion DCL050-XE
Summary of Contents for DeWalt XR Li-Ion DCL050-XE
- Page 1 INSTRUCTION MANUAL DCL050-XE 18V LED HAND-HELD WORKLIGHT...
-
Page 3: Definitions: Safety Guidelines
SAVE ALL WARNINGS AND INSTRUCTIONS FOR Definitions: Safety Guidelines FUTURE REFERENCE The definitions below describe the level of severity for each signal The term “power tool” in the warnings refers to your mains-operated (corded) power word. Please read the manual and pay attention to these symbols. tool or battery-operated (cordless) power tool. -
Page 4: Electrical Safety
under the influence of drugs, alcohol or medication. A moment of inattention e) Maintain power tools. Check for misalignment or binding of moving parts, while operating power tools may result in serious personal injury. breakage of parts and any other condition that may affect the power tool’s operation. -
Page 5: Extension Cords
factory tested; if this tool does not operate, check the power supply. Your D WALT or DC ..direct current or AC/DC ..alternating or tool is double insulated, therefore no earth wire is required....Class I Construction ......direct current • Young children and the infirm. This appliance is not intended for use by young (grounded) no .......no load speed children or infirm persons without supervision. -
Page 6: Important Safety Instructions For All Battery Chargers
Important Safety Instructions for All Battery Chargers NOTE: Do not store the battery packs in a tool with the trigger switch locked on. Never tape the trigger switch in the ON position. SAVE THESE INSTRUCTIONS: This manual contains important safety and operating WARNING: Fire hazard. -
Page 7: Charge Indicators
Indicator Light Operation • Do not place any object on top of the charger or place the charger on a soft surface that might block the ventilation slots and result in excessive internal heat. Place the charger in a position away from any heat source. The charger is PACK CHARGING ventilated through slots in the top and the bottom of the housing. -
Page 8: Important Charging Notes
NOTE: This could also mean a problem with a charger. supply when there is no battery pack in the cavity. Unplug the charger before attempting to clean. PROBLEM POWERLINE 7. Do not freeze or immerse the charger in water or any other liquid. Some chargers have a problem powerline indicator. - Page 9 Installing and Removing the Battery Pack (Fig. 3) FIG. 2 WARNING: To reduce the risk of injury, never depress the battery release button without removing the battery pack. Depressing the battery release button without removing the battery pack can result in the battery pack falling out unexpectedly. NOTE: For best results, make sure your battery pack is fully charged.
- Page 10 NOTE: The fuel gauge is only an indication of the charge left on the battery pack. HANG HOOK (FIG. 5) It does not indicate tool functionality and is subject to variation based on product The telescopic hang hook (b) extends out of the pivoting head (c). The hang hook components, temperature and end-user application.
- Page 11 (including brush inspection and replacement) should be performed by certified service centers or other qualified service organizations, always using identical replacement parts. Accessories WARNING: Since accessories, other than those offered by D WALT, have not been tested with this product, use of such accessories with this tool could be hazardous. To reduce the risk of injury, only D WALT recommended accessories should be used with this product.
- Page 12 The battery voltage is nominal, it can measure above or below depending on the state of charge. Stanley Black & Decker 82 Taryn Drive, Epping, VIC 3076 Australia • 1800 338 002 (Aust) or 0800 339 258 (NZ) www.dewalt.com.au • www.dewalt.co.nz (JAN14) Part No. N369319 DCL050-XE Copyright ©...