DeWalt DCL030-XE Instruction Manual page 9

NOTE: Battery packs should not be stored completely depleted of charge. The battery
pack will need to be recharged before use.
SAVE THESE INSTRUCTIONS FOR FUTURE USE
COMPONENTS (Fig. 2)
WARNING: Never modify the power tool or any part of it. Damage or personal
injury could result.
A. Switch
B. Loop
C. Pivoting head
D. Battery pack
FIG. 2
A
E
E. Battery release button
F. Belt hook (optional accessory)
G. Belt hook screw
C
B
G
F
D
D
7
OPERATION
WARNING: To reduce the risk of serious personal injury, turn light off and
disconnect tool from power source before making any adjustments or removing/
installing attachments or accessories.
Installing and Removing the Battery Pack (Fig. 3)
NOTE: For best results, make
FIG. 3
sure your battery pack is fully
charged.
To install the battery pack (D)
E
into the tool handle, align the
battery pack with the rails
inside the tool's handle and
slide it into the handle until the
battery pack is firmly seated in
the tool and ensure that it does
not disengage.
To remove the battery pack
from the tool, press the release
button (E) and firmly pull the battery pack out of the tool handle. Insert it into the
charger as described in the charger section of this manual.
Switch (Fig. 2)
To turn the light on, press the switch (A). To turn it off, press
the switch again.
Pivoting Head (Fig. 2, 4)
The pivoting head (C) rotates to provide light in the range of
-10° to 100°.
Carrying and Suspending the Light (Fig. 2, 5)
CAUTION: When light hangs by the belt hook (F) or loop
(B), do not shake the light or the object from which it hangs.
Do not hang the light from any electrical wires or anything
that is not secure. Personal injury or property damage may
occur.
D
FIG. 4