Visual Control Of Details; Stich Plate; Presser Foot; Feed Dog - Husqvarna 1200 Service Manual

VISUAL CONTROL OF DETAILS

Stitch plate
Requirements
The stitch plate must not be damaged in any way.
Particular attention should be paid to possible damage or
unevenness around the needle hole.
Action
Exchange the damaged stitch plate.
Mounting of a new stitch plate
In order to get the stitch plate into the correct position it
should be first mounted with the spring (A) and screws (B)
somewhat loose. Thereafter remove the stitch plate, fasten
the screws an remount the stitch plate.
Setting to needle, (P.29).

Presser foot

Requirements
There should be no scratches on the underneath of
the presser foot.
Action
Exchange a damaged presser foot.
Comments
How the fabric is held between the presserfoot and
the stitch plate plays an important role in the stitch
formation. Refer to all presser feet.
See Operating Manual.

Feed dog

Requirements
The top side of the feed dog must not be damaged
in any way, e.g. broken teeth etc.
It should be free from fluff and pieces of thread.
Compare with Operating Manual:
"Care of the machine".
Action
The faulty dog should be exchanged.
Remove the stitch plate.
Undo the screws and replace the feed dog.
As regards to the settings of the feed dog (P.34-35).
8 Husqvarna service manual 104 72 30-26
SEWKNITWORLD