Pre-Setting Of The Step Motor Of The Side Motion - Husqvarna 1200 Service Manual

22 Pre-setting of the step motor for the side feeding
Reqirements
Dismount the side feeding mechanism (page 56)
Set the handwheel so that the step motor switches between its 2 positions.
Choose a side feeding stitch from casette L.
Turn the handwheel in such a way that the step motor changes between its 2 positions.
The distance between the pin (B) and the side of the segment shall be equally large in both
positions
(see fig. 1).
Adjustment
Turn on the mains switch of the machine.
Choose a side feeding stitch from casette L.
Loosen screw (A) and place the cog segment in such a way that pin (B) arrives in the middle of
the opening of the cog segment (see fig. 2).
Tighten screw (A). Check according to requirements.
Fig.1 Fig. 2
SEWKNITWORLD
42 Husqvarna service manual 104 72 30-26