The Sideways Setting Of The Feeding Mechanism - Husqvarna 1200 Service Manual

23 Setting the feeding mechanism sideways
Requirements
Set the machine on a stitch from casette L with side feeding. A play of at least 0.3 mm shall be:
in one side feeding position between bearing/bearing clamp (B) and link (C) of the feeding
device and in the other side feeding position between bearing/bearing clamp (D) and link (E) of
the feeding device.
Adjustment
Loosen screws (A) and push the step motor unit with the feeding device sideways.
Tighten the screws.
Check the play according to requirements.
NOTE!
The spherical bearings (B) and (D) must be trued so that the feeding device can move easily.
Min 0,3 Min 0,3
SEWKNITWORLD
104 72 30-26 Husqvarna service manual 43