2.7
Installing the Card in Another PCI Slot
As suggested in section 2.6, if you need to switch the PCI-DMC-A01 card to another free PCI
slot in the system, please first discharge any static electricity, disconnect the system power
supply, and then remove the PCI-DMC-A01 card. Follow the instructions in section 2.2.3 to
re-install the card.
Once you have switched the PCI-DMC-A01 card to another free PCI slot on the
system, check to see if the drivers have been installed on the system before your
restart. If they are not yet installed, please skip the following section and go to section
2.8 "Manual Driver Installation".
When the PCI-DMC-A01 card has been properly installed in the new PCI slot and the system
restarted, the "Found New Hardware Wizard" window (see Fig. 2.33) will pop-up. Select "No,
not this time", and then click "Next" to continue.
Revised May, 2012
Chapter 2 Installation | PCI-DMC-A01 / PCI-DMC-B01
Figure 2.33
2-23