Table of Contents
Advertisement
main menu
Setting the ptZ
To use Camera's PTZ functions, ID and protocols of each camera and DVR should be matched.
For other settings, refer to the <Remote Device> settings. (Page 54)
Using the mouse may help make setup easier.
1. Use the up/down buttons (▲▼) in <Device> window to
move to <Camera>, and press [eNteR] button.
2. Select <ptZ>.
A window of PTZ settings appears.
3. Use direction buttons (▲▼_ +) to move to a desired item,
and select it.
• Port : Select a port control method for the camera that is
connected to a channel.
You have two choices : <RS-485> and <Coaxial>.
`
<Coaxial> type is only available for SRD-1680D SD channel.
`
• ID : Set the ID of the connected camera of each channel.
You can easily setup by using the numeric buttons on the remote control or front panel.
• Protocol : Set the protocol of the connected camera of each channel.
You can check the camera's ID and protocol if you turn the camera off and on after connecting it to the DVR.
`
M
For the <Coaxial> type, CCVC and PELCO-C protocols are supported.
`
<Coaxial> type is only available for SRD-1680D SD channel.
`
Coaxial function doesn't work on HD-SDI Channels.
`
4. When the PTZ setup is done, press <OK>.
50_ main menu
Camera
PTZ
Camera
CH
Port
ID
1
RS-485
0
>
2
RS-485
1
>
3
RS-485
2
>
4
RS-485
3
>
5
RS-485
4
>
6
RS-485
5
>
7
RS-485
6
>
8
RS-485
7
>
OK
Cancel
Protocol
None
None
None
None
None
None
None
None
Previous/Next Page
- Quick Links:
- User Manual
Hide quick links:
Advertisement
Table of Contents
