Table of Contents
Advertisement
Adjusting the projected image
Auto-adjusting the image
In some cases, you may need to optimize the picture quality. To do this, press AUTO on
the projector or remote control. Within 3 seconds, the built-in Intelligent Auto
Adjustment function will re-adjust the values of Frequency and Clock to provide the best
picture quality.
The current source information will be displayed in the corner of the screen for 3 seconds.
This function is only available when PC signal (analog RGB) is selected.
Fine-tuning the image clarity
Sharpen the image by rotating the focus ring.
Correcting keystone
Keystoning refers to the situation where the projected image is noticeably wider at either
the top or bottom. It occurs when the projector is not perpendicular to the screen.
To correct this, follow ONE of these steps:
•
Press
control to display the Keystone correction page.
Press
the image. Press
the bottom of the image.
•
Using the OSD menu
1.
Press MENU/EXIT and then press
2.
Press
correction page displays.
3.
Press
keystoning at the bottom of the image.
/
on the projector or remote
to correct keystoning at the top of
to correct keystoning at
to highlight Keystone and press MODE/ENTER. The Keystone
to correct keystoning at the top of the image. Press
/
Press
/
until the DISPLAY menu is highlighted.
/ .
Press
.
to correct
Operation
21
Advertisement
Table of Contents
