Four Bay Ethernet Cradle
This section describes how to use a Four Bay Ethernet cradle with the MC9500-K. For setup and cradle
communication setup procedures refer to the MC9500-K Mobile Computer Integrator Guide.
The Four Bay Ethernet cradle:
•
Provides 5.4 VDC power for operating the MC9500-K.
•
Connects up to four MC9500-K devices to an Ethernet network.
•
Simultaneously charges up to four MC9500-K devices.
•
Mounts on a wall or desktop using the appropriate mounting bracket.
Communication and Charging
To charge the MC9500-K battery and communicate with a host computer:
Ensure that the cradle is connected to power and an Ethernet hub.
1.
Align and hook the MC9500-K interface pocket onto the cradle's cleat. If available, use the guide to assist in
2.
placement of the MC9500-K onto the cradle. See
Four Bay Ethernet Cradle with Optional Guide Cups
Figure 8-6
The MC9500-K's Battery Status LED shows the status of the battery charging in the MC9500-K. See
page 1-7
for charging status indications. The 4800 mAh battery fully charges in less than six hours.
Figure 8-4 on page
8-7.
Accessories
8 - 9
Table 1-1 on