Wall Mounting Template; Preparing The Wall - IDEAL Classic LXRS 230 Installation And Service Manual

9

WALL MOUNTING TEMPLATE

1. Tape the template to the wall in the selected position.
Ensure squareness by use of a plumbline, as shown.
2. Mark out the position of the 3 wallplate screws, choosing
one from each group of 3 holes. Also mark the position of
the hole for the duct, the jacking screw and the top cover
plate screws.
3. Drill the 3 holes, 8 mm (
plugs. Drill the jacking screw and the top cover plate
screw holes 7mm (9/32") and insert the plastic plugs.
4. Remove the template from the wall.

10 PREPARING THE WALL

IMPORTANT.
The wall must be of suitable load bearing capacity.
1. Cut the appropriate hole in the wall for insertion
of the terminal assembly.
Note. The terminal must not come into contact
with a combustible material such as that used
in the non-standard construction of timber
framework and plasterboard etc.
2. Fix the mounting plate to the wall with the 3
No.14 x 50 mm screws provided.
11 CHECKING THE BOILER
Check the jacking screw is fitted and screwed home.
12
INSTALLATION
), and insert the 3 plastic
5/16"
Rear View of Boiler
Classic LX, RS -
Installation