FujiFilm FinePix4800Zoom Service Manual page 2

SAFETY CHECK-OUT
After correcting the original problem, perform the following safety
check before return the product to the costomer.
1. Check the area of your repair for unsoldered or
poorly soldered connections. Check the entire
board surface for solder splasher and bridges.
2. Check the interboard wiring to ensure that no
wires are "pinched" or contact high-wattage
resistors.
3. Look for unauthorized replacement parts,
particularly transistors, that were installed
during a previous repair. Point them out to the
customer and recommend their replacement.
4. Look for parts which, though functioning, show
obvious signs of deterioration. Point them out
to the customer and recommend their
replacement.
5. Check the B + voltage to see it is at the values
specified.
2
FinePix4800Zoom(U/E/EG) SREVICE GUIDE
6. Make leakage - current measurements to
determine that exposed parts are acceptably
insulated from the supply circuit before returning
the product to the customer.
7.
CAUTION: FOR CONTINUED
PROTECTION AGAINST FIRE
HAZARD, REPLACE ONLY WITH
RISK OF FIRE-
SAME TYPE 2.5 AMPERES 125V
2.5A125V
REPLACE FUSE
FUSE.
AS MARKED
ATTENTION: AFIN D'ASSURER
2.5A125V
UNE PROTECTION PERMANENTE
CONTRE LES RISQUES
D'INCENDIE, REMPLACER
UNIQUEMENT PAR UN FUSIBLE
DE MEME, TYPE 2.5 AMPERES,
125 VOLTS.
8.
WARNING:
TO REDUCE THE ELECTRIC
WARNING!
SHOCK, BE CAREFUL TO TOUCH
THE PARTS.
HIGH VOLTAGE