Important Information For Users In The United Kingdom; For Your Safety (Australia Only); Caution (New Zealand Only) - Canon FAX-L2000 Reference Manual

Important Information for Users in the
United Kingdom
This equipment is intended for connection to analogue two wire public telecommunication
networks.
Connect the supplied cable to this socket first, then to the telephone line.
This socket is intended for connection of the Canon optional telephone. If required, an
adapter to connect any piece of approved telecommunications apparatus is available
from your Canon supplier.
Canon recommend that any additional equipment connected in the installation is connected to
this "handset" socket. Do not connect additional equipment through parallel sockets elsewhere
on the telephone line.
Voltage and current available at these sockets is determined by the network to which the line
cable is connected. They will not normally exceed the limits for TNV as described in EN60950.
This equipment is not intended or recommended for making calls to emergency services.

For Your Safety (Australia Only)

To ensure safe operation the three-pin plug supplied must be inserted only into a standard
three-pin power point which is effectively earthed through the normal household wiring.
Extension cords used with the equipment must be three-core and be correctly wired to provide
connection to earth. Wrongly wired extension cords are a major cause of fatalities.
The power point shall be located near the equipment and shall be easily accessible.
The fact that the equipment operates satisfactorily does not imply that the power point is
earthed and the installation is completely safe. For your safety, if in any doubt about the
effective earthing of the power point, consult a qualified electrician.

Caution (New Zealand Only)

• This equipment may not necessarily provide for the effective hand-over of a call to or from a
telephone connected to the same line.
• The operation of this equipment on the same line as telephone or other equipment with
audible warning devices or automatic ring detectors will give rise to bell tinkle or noise and
may cause false tripping of the ring detector. Should such problems occur, the user is not to
contact Telecom faults service.
xiii