Threading For Bobbin Winding - Janome MEMORY CRAFT 9700 Instruction Book

2
1
4
2
6

Threading for bobbin winding

1 Hold the upper thread with both hands and place it
down into the Slit.
3
2 Guide the thread around the Thread Guide following
the dashed line as shown in the diagram.
3 Thread through the hole in the Bobbin from the
inside to the outside. Put the Bobbin on the Bobbin
Winder Spindle.
4 Push it to the right.
5 Hold the free end of the thread in your hand and
depress the foot control.
Stop the machine after the bobbin has made
several turns, and cut the thread close to the hole
in the bobbin.
5
6 Depress the Foot Control again. When the Bobbin
1
is fully wound, it will stop automatically.
Release the Foot Control and return the Bobbin
Winder Spindle to its original position by moving it
to the left, and cut the thread with the Bobbin
Thread Cutter as shown.
1 Bobbin Winder Stopper
2 Bobbin Thread Cutter
NOTES:
The machine will not sew until the spindle has been
returned to the left.
You can use either the Foot Control or the Start/Stop
Button to wind the Bobbin.
For safety purposes, the machine will stop
automatically 1.5 minutes after starting bobbin
winding.
13