Install Hood Assembly And Bags - Exmark Lazer HP Operator And Parts Manual

8. Re-install the deck drive belt in the lower groove of the double sheave. Install
plug (Item 27) into bore of double sheave.
9. Install 5/16-18 x .62 screw (Item 26) into hole that 5/16 – 18 x 3 ¼ bolt was
removed from on the deck. Use the whizlock nut removed in step 1. Install bolt
with head to inside of deck.
10. Install the new belt cover (Item 25) secure with the two belt shield knobs (Item
22) as shown in Figure 2.
NOTE: Do not re-install the 5/16 x 3 1/4 bolt that was removed in step 1.

3.3 INSTALL HOOD ASSEMBLY AND BAGS

44 and 48 inch units (52 inch units skip to step 3)
Note: When installing Ultra Vac on Lazer Z HP model LHP4818KC with serial numbers
below 176621, refer to additional necessary instructions included in adapter kit 103-0328.
1. Remove and discard the (8) bolts that retain the "HOT" engine guard shield (Item 1). Keep
the nuts for use in Step 2.
2. Install the Bagger Mount Weldment (Item 2) and engine guard shield using the 5/16-18 x 1
Screws provided (Item 3) and whizlock nuts removed in step 1. Continue at step 7.
52 inch units
3. Remove and discard the (8) bolts that retain the rear weight (Item 12). Keep the whizlock
nuts for use in step 5.
4. Install the Bagger Mount Weldment (Item 2) to the rear of the frame using (4) 5/16-18 x 1
screws (Item 3) and (4) 5/16 – 18 whizlock nuts (Item 15). Use only the bottom four holes
on the Bagger Mount Weldment
5. Install the counterweight spacer (Item 13) at the rear of the mower between the
counterweight and frame using the lower set of screws.
6. Install the Rear Weight (Item 12) and spacer (Item 13) from the drive kit using the (8) 5/16
– 18 X1.75 screws (Item 14) and whizlock nuts removed in step 3.
All units
7. Slide tube ends of Hood Assembly (Item 4) into the tubes of the mount weldment. Install
(2) clevis pins (Item 16) through holes in tubes. Retain with (2) Hair Pins (Item 17).
8. Hang the (2) Bag Assemblies (Item 5) from the slots in the Bagger Upright. Close and
latch hood.
FIGURE 7
14