Exmark Lazer HP Operator And Parts Manual page 12

9. Verify that the distance between front and rear swivel blocks is the same as
dimension A recorded in step 4. Adjust the position of the front swivel block if
dimension A is not met.
10. Remove the blocks from under the deck so that it hangs freely from all four chains.
11. Set the deck lift lever to the 4.5" cutting height position (also transport position).
Adjust the spring tension until proper distance is obtained between the two washers
(See Fig 3) by turning the nut at the front of the spring. Lock the nut in position with
the jam nut.
12. If the deck is out of adjustment after completing the procedure listed above, refer to
your Lazer HP owners manual for full deck adjustment procedures.
NOTE: When above adjustments have been made, the front of the deck will be
slightly lower than the rear of the deck.
13. Locate and drill a new hole for the chute tabs 2" down from the top and 3/8" from
the outside of the tabs. See Figure 4.
14. Cut off the chute tabs 1 5/8" down from the top. See Figure 4.
15. Install the new discharge chute (Item 20) using the chute pivot pin (Item 18) and
hairpin (Item 19) provided as shown in Figure 5.
FIGURE 4
FIGURE 5
12