Table of Contents
Advertisement
[INSTALLATION PRECAUTIONS]
! When installing and removing this module from the GOT main module be
sure to shut off the power at all external switches. If all the switches are not
turned off, the module could be damaged or malfunction.
! When connecting the bus connection cable to this module be sure to turn
off the switch to all external power switches to the GOT and PC CPU. If all
the switches are not turned off, it may cause malfunction.
! Use this module in an environment that is within the general specifications
written in the GOT User's Manual. If the power supply is used in an
environment that is outside of the general specifications then electric
shock, fire, malfunction, or product damage or degradation could occur.
! For a correct installation, insert the bus connection cable to this module,
A7GT-BUS2S, bus connector conversion module, and base unit connector
until you hear it click.
A bad connection could cause erroneous input or output.
! When installing this module in the GOT main module, install it in the GOT
installation area and be sure it is fastened with a module fastening screw
that is tightened within the specified torque range.
If the module fixing screws are loosen, it may cause malfunction, damage
or falling of the module.
If the module fixing screws are too tight, the GOT main module or the
screws could break.
[Wiring Instructions]
! Before starting wiring, always switch off all phases of the power supply
externally.
! During wiring, care should be taken so that foreign matter such as shield
and wire offcuts do not enter this unit.
Otherwise, a fire, fault or misoperation can occur.
DANGER
CAUTION
DANGER
CAUTION
A-2
Advertisement
Table of Contents
