Craftsman Professional 137.212210 Operator's Manual page 37

33.9° BEVEL DETENT PIN FOR
CROWN MOULDINGS (FIG. JJ)
NOTE: A bevel detent pin is
incorporated into this machine for quick
bevel adjustments when the desired
bevel angle is 33.9
1. Push the bevel detent stop pin (1)
in toward the front of the machine.
2. Loosen the bevel lock handle (2).
3. Rotate the cutting head until the
bevel detent pin stops the bevel
angle at 33.9° on the bevel scale.
4. Tighten the bevel lock handle
before you make your cut.
Fig. JJ
2
COMPOUND CUT (FIG. KK)
1. Extending the fence by sliding it out
to the required location or remove
the right sliding fence if necessary.
See "SLIDING FENCE or REMOVE
SLIDING FENCE".
2. Set the desired bevel angle using
the bevel lock handle (1).
3. Set the desired miter angle and
lock into position. See "MITER
CUT".
.
o
1
Fig. KK
CHOP CUTTING NARROW BOARDS-
o
90 CROSSCUT (FIG. LL)
1. For a chop cutting operations on
small workpieces, slide the cutting
head assembly completely toward
the rear of the unit and tighten the
carriage lock knob (1).
2. Position the cutting head to the
0° bevel position and lock the bevel
lock handle (2).
3. Position the table to the 0° miter
angle and lock the quick cam miter
table lock (3).
4. Position the workpiece on the table
and against the fence. Use a hold
down clamp (4) attached to the
base, whenever possible.
5. Pull the trigger (5), turning on the
saw. Lower the blade by pushing
the handle (6) down into the
workpiece with slow and even
pressure.
6. When the cut is complete, release
the switch and allow the blade to
stop before raising the cutting head
assembly.
37 37
1