Craftsman Professional 137.212210 Operator's Manual page 34

TO TURN THE SAW ON (FIG. DD)
Depress the trigger switch (1) to turn
on the miter saw started.
NOTE: Make the ON/OFF switch
childproof. Insert a padlock, or chain
with padlock, through the holes (2) in
the trigger switch, locking the tool's
switch, preventing children and other
unauthorized users from turning the
machine on.
The miter saw is equipped with an
automatic blade brake. When the
trigger switch is released, the electric
blade brake will stop the blade within
approximately 10 seconds.
Fig. DD
2
1
SLIDING FENCE (FIG. EE)
WARNING
!
●
The sliding fence must be
extended to the left or right when
making bevel cuts.The sliding
fence noted three bevel angles
where the user must adjust the
fences to match the degree of
the bevel cut. Failure to extend
the sliding fence will not allow
enough space for the blade to
pass through which could result
in serious injury. At extreme
miter or bevel angles the saw
blade may also contact the
fence.
●
The right side sliding fence must
be removed when making any
right bevel angle cuts greater
than 35 in combination with
0
any right hand miter angle. This
fence must also be removed
whenever a 45
is desired with a miter angle
greater than 22.5
1. Unlock the fence cam locking lever
(1) by pushing it toward the rear of
the machine.
2. Extend the fence (2) by sliding it out
to match the degree of the bevel
cut. Lock the fence cam locking
lever by pushing it IN toward the
fence. NOTE: When transporting
the saw, always secure the sliding
fence in the collapsed position
(toward the saw blade).
Fig. EE
1
34 34
bevel angle
0
.
0
2