Craftsman Professional 137.212210 Operator's Manual page 36

4. Once the desired miter angle is
achieved, press down on the quick
cam miter table lock to secure the
table into position.
5. If the miter angle desired is NOT
one of the ten positive stops noted
above, simply lock the table at the
desired angle by pressing down on
the quick-cam miter table lock (2).
Fig. HH
4
3
BEVEL CUT (FIG. II)
WARNING
!
●
The sliding fence must be
extended to the left or right when
making bevel cuts.The sliding
fence noted three bevel angles
where the user must adjust the
fences to match the degree of
the bevel cut. Failure to extend
the sliding fence will not allow
enough space for the blade to
pass through which could result
in serious injury. At extreme
miter or bevel angles the saw
blade may also contact the
fence.
●
The right side sliding fence must
be removed when making any
right bevel angle cuts greater
than 35 in combination with
o
any right hand miter angle. This
2 1
fence must also be removed
whenever a 45
is desired with a miter angle
greater than 22.5
Tilt the cutting head to the desired
angle as shown on the bevel scale. The
blade can be positioned at any angle,
from a 90° straight cut (0° on the scale)
to a 45° left and right bevel. Tighten the
bevel lock handle (1) by pushing down
to lock the cutting head in position.
Bevel positive stops are provided at 0°,
33.9° and 45°.
Fig. II
1
NOTE: The saw comes with a
33.9° bevel detent pin for setting up
crown molding cuts when the angle of
the walls equals 90°.
36 36
bevel angle
o
.
o