Craftsman Professional 137.212210 Operator's Manual page 19

Fig. F
2
POWER CORD STORAGE CLIPS
(FIG. G)
For convenience and to prevent
damage to the power cord when
the miter saw is not in use or is in
transportation, the slide carriage has
two clips on the rear for cord storage.
To assembly these clips:
1. Attach each power cord storage
clips (2) to the rear of slide-bar seat
with one mounting screws (1).
Fig. G
2
1
SAW BLADE WRENCH (FIG. H)
For convenient storage and prevention
of loss, there is a clip (1) located at the
left rear foot of the base for storing the
blade wrench (2).
Fig. H
1
!
3
To avoid injury, disconnect the
plug from the power source before
performing any adjustments or
repair.
NOTE: Your miter saw was adjusted at
the factory. However, during shipment
slight misalignment may have occurred.
Check the following settings and adjust
if necessary prior to using this miter
saw.
REMOVING AND INSTALLING THE
TABLE INSERT (FIG. I)
!
To avoid injury:
●
Always unplug the saw to avoid
accidental starting. Remove all
small pieces of material from the
table cavity before performing
any cuts. The table insert may
be removed for this purpose, but
always reattach the table insert
prior to performing a cutting
operation.
●
Do not start the sliding compound
miter saw without checking for
interference between the blade
and table insert. Damage could
result to the blade, table insert or
turntable if blade strike occurs
during the cutting operation.
19 19
WARNING
WARNING
1
2