Battery Recharge - Panasonic KX-TG7892AZ Operating Instructions Manual

Useful Information
Problem
I cannot connect a cellular
phone to the base unit.
I cannot hear a dial tone.
The base unit beeps.
Programmable settings
Problem
I cannot register a handset to a
base unit.

Battery recharge

Problem
The handset beeps and/or
flashes.
I fully charged the batteries, but
– still flashes,
– is displayed, or
– the operating time seems to
be shorter.
70
Cause/solution
R Confirm that your cellular phone is turned on.
R Confirm that your cellular phone is within base unit range
(page 14).
R Depending on the state of the wireless environment, such
as the presence of any electrical interference, there may
be a delay even if the auto connection feature is turned
on. You can connect to the base unit manually (page 19).
R The cellular phone has not been paired to the base unit.
Pair the cellular phone (page 17).
R Make sure that the CELL 1 or CELL 2 indicator lights up
(page 15).
R The base unit's AC adaptor or telephone line cord is not
connected. Check the connections.
R Disconnect the base unit from the telephone line and
connect the line to a known working telephone. If the
working telephone operates properly, contact our service
personnel to have the unit repaired. If the working
telephone does not operate properly, contact your service
provider/telephone company.
R New messages have been recorded. Listen to the new
messages (page 56).
Cause/solution
R The maximum number of handsets (6) is already
registered to the base unit. Cancel unused handset
registrations from the base unit (page 45).
Cause/solution
R Battery charge is low. Fully charge the batteries (page 11).
R Clean the battery ends (
with a dry cloth and charge again.
R It is time to replace the batteries (page 11).
, ) and the charge contacts