Panasonic KX-TG7892AZ Operating Instructions Manual page 45

Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
is not registered to the base unit, re-register
the handset.
1
Handset:
MMENUN#130
2
Base unit:
Press and hold MLOCATORN for about 5
seconds until the registration tone sounds.
R If all registered handsets start ringing,
press MLOCATORN again to stop, then
repeat this step.
R The next step must be completed
within 90 seconds.
3
Handset:
Press MOKN, then wait until a long beep
sounds.
Note:
R While registering, "Base in
registering" is displayed on all
registered handsets.
R When you purchase an additional handset,
refer to the additional handset's installation
manual for registration.
Deregistering a handset
A handset can cancel its own registration to
the base unit, or other handsets registered to
the same base unit. This allows the handset to
end its wireless connection with the system.
1
MMENUN#131
R All handsets registered to the base unit
are displayed.
2
MbN: Select the handset you want to
cancel. a MSELECTN
3
MbN: "Yes" a MSELECTN
4
MOFFN
Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 4. Contact your Panasonic dealer for
details.
Important:
R Before registering the repeater to this base
unit, you must turn the repeater mode on.
R Do not use more than one repeater at a
time.
Setting the repeater mode
Handset
1
MMENUN#138
2
MbN: Select the desired setting. a
MSAVEN a MOFFN
Note:
R After turning the repeater mode on or off,
may be displayed on the handset
momentarily. This is normal and the
handset can be used once
Registering the DECT repeater
(KX-A405AL) to the base unit
Note:
R Please use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
referring to the Installation Guide for the
DECT repeater.
1
Base unit:
Press and hold MLOCATORN for about 5
seconds until the registration tone sounds.
R The next step must be completed
within 90 seconds.
2
DECT repeater:
Connect the AC adaptor, then wait until
the indicator and
green.
3
Base unit:
To exit the registration mode, press
MLOCATORN.
R The registration tone stops.
Programming
is displayed.
indicator light
45