Pioneer DVR-65H-S Training Manual page 71

<<How to use diagnostic tool>>
- How to enter
- How to exit
<<Notes>>
Although a diagnostic tool operates regardless of the unit function, since it may malfunction,
please do not operate the unit during HDD diagnostic tool operation. And the recommendation
states of the unit are all "stop", "No timer recording", and an input selection "L1~L3"
<<diagnostic method>>
1) Display a menu screen.
The following screens will be displayed if it goes into a diagnostic tool.
In order to go into each mode, press [1] ~ [4] of test remote control unit.
HDD CHECK MODE
1 HDD Information
2 S.M.A.R.T. Attribute Information
3 S.M.A.R.T. DST
4 HDD R/W Check
2) Check HDD information.
Press [1] and check the following information. A check item is as follows.
Model: Is the part number of HDD displayed correctly?
Recog.No: Is the positive value displayed?
SMART threshold: Is "not exceeded" displayed?
When "exceeded" is displayed, the HDD should be replaced.
HDD Information
Cylinders:0x3FFF
Sec/Track:0x003F
Model :Maxtor 4R080L0
Firmware :RAMC1TUO
SN :R22RRL2SE
Major No :ATA/ATAPI-7
Life Time:33h 10m 30s
Recog. No:-1
SMART threshold: not exceeded
After the above checks, press [Clear] to return to a menu screen.
The diagnostic method
: Press [ESC] + [CX] + [0] + [1]
: Press [ESC]
[1-4]
Heads:0x0010
[The test to perform]
(1) HDD Information
The check of HDD information
(2) S.M.A.R.T.DST
A simple test and all reading test
(3) HDD R/W Check
Complete writing and reading test
If this test is performed,
all the data in HDD is eliminated.
* "2.SMART Attribute ..." does not use.
[Check item]
(1) Model
Refer to S/M regarding the model number
of HDD.
(2) Recog.No
Positive value : HDD is recognized.
Negative value : HDD is not recognized.
(3) SMART threshold
exceeded : HDD should be replaced
not exceeded : Normal (it is not a life yet)
71