Ping Watchdog - D-Link DAP-3310 User Manual

Section 3 - Configuration
This page will allow you to configure the Ping Watchdog
function of the AP. Ping Watchdog works by sending
ICMP "echo request" packets to a target host and listens
for ICMP echo response replies. Ping Watchdog is
enabled by default.
Ping
Select whether the ping watchdog function is
Watchdog: Disabled or Enabled.
IP Address to
Enter the IP address that will be used for the
Ping:
AP to ping.
Ping Interval:
Set the amount of time in seconds that the AP
will wait between pings.
Startup Delay:
Set the amount of time in seconds that the AP
will wait before beginning to ping the target
host.
Failure Count Set the number of times that the ping will fail
to Reboot:
before the ping watchdog will force the AP to
reboot.
D-Link DAP-3310 User Manual

Ping Watchdog

52