Reset Output; Basic Zone Configuration; Expanded Zone Configuration; Gem-P9600 Installation Instructions - Gemini GEM-P9600 User Manual

!
Page 16

RESET OUTPUT

15
Reset Output can be activated depending on the programming options selected (see GEM-
RESET
P9600 Programming Instructions). Connect the device controlled by the programmable output
OUTPUT
between terminal 15 (+) and terminal 14 (-).

BASIC ZONE CONFIGURATION

The basic zone configuration for the GEM-P9600 is 8 zones. Connect as shown above to terminals 16-27. Normally
Closed (N.C.) devices may be wired in series or Normally Open (N.O.) devices may be wired in parallel. Use the 2.2K
Ohm end-of-line (E.O.L.) resistor in each zone, if selected in programming (refer to the GEM-P9600 Programming In-
structions). Zones 1-8 can be selected for a "Fast Loop Response (10ms or 50 ms)" or a "Normal Loop Response (750
ms)". Other zone options include Zone Type (Entry/Exit, Interior, 24 Hour Protection, Trouble and Fire), Instant, Chime,
Area Selection and Relay Output selection.

EXPANDED ZONE CONFIGURATION

The GEM-P9600 Control Panel may be expanded up to 96 zones. This may be accomplished by adding 88 zones to the
basic 8 zone configuration. Hardwired zone expanders include: GEM-EZM4 (4 additonal zones per module), GEM-
EZM8 (8 additional zones per module) and GEM-RP1CAe2 Keypad (4 additional zones per keypad). Wireless zone ex-
panders include: GEM-RECV8 (8 additional zones per receiver), GEM-RECV16 (16 additional zones per receiver) and
GEM-RECV96 (88 additional zones per receiver). Wireless transmitters include: GEM-TRANS2, GEM-KEYF, GEM-SMK,
GEM-PIR, GEM-DT and GEM-GB.
X

GEM-P9600 Installation Instructions

Additional Zones are numbered 9-96.
GEMINI
SYSTEM ARMED
01/01/97 12:00AM
N EX T/YES
A 1 2 3 E
D
PR IO R /NO
B 4 5 6 F
AREA
C 7 8 9 0 G
CO MPUTERIZED SE CURITY SYSTEM
R
GEM-RP1CAe2
(2 LINE LCD KEYPAD)
WI742D 5/03
L
NAPCO Security Systems