Service Procedures; Removal Of Lid; Components In Console Area; Removal Of Display Module - Fisher & Paykel SMARTDRIVE PHASE 7 Service Manual

517790C
10

SERVICE PROCEDURES

In order to service and to gain access to components within SmartDrive
be followed. These procedures are set out below.
Servicing note
(a) To avoid stripping screws, do not overtighten when re-assembling parts. If using a power
screwdriver, have the torque setting on low.
(b) Take care not to damage wire terminals on removal as some of these have release clips.
(c) On completion of any service carried out to the washing machine, all safety tests as required
by law must be carried out.
10.1

Removal of Lid

(a) Open the lid fully, then lift off vertically.
Reassembly
Refit in reverse manner, ensuring that the hinge
lugs on the lid are vertical.
10.2

Components in Console Area

(a) Remove the lid. (Refer to Section 10.1).
(b) Remove the two screws at the rear of the console securing the console to the top deck.
(c) Tilt the console forward.
Reassembly:
Refit in reverse manner.
10.3

Removal of Display Module

(a) Follow instructions for removal of console.
(Refer to Section 10.2).
(b) Disconnect the wiring harness from the
Motor Control Module.
(c) Push the tab clear and slide the module.
(d) Lift the display module clear of the console.
Reassembly:
Refit in reverse manner.
Lift
Push tab
46
®
, certain procedures must
Slide tab