Hot Bowl Flag; Data Download; User Warnings - Fisher & Paykel SMARTDRIVE PHASE 7 Service Manual

517790D
To turn the recycle feature on follow the procedures below:
1. Enter diagnostic mode (Refer to Section 4).
2. Press WATER LEVEL UP so that the Medium water level LED is lit.
3. Press POWER to turn the display off (the 3 rightmost wash progress LEDs will be flashing).
4. Press POWER to turn the machine on.
The machine can now be tested on any cycle.
Note: This feature is designed as a service aid only and should be OFF in the customer's
home. To return to normal operation, and to return the recycle feature to the factory
setting, switch the machine off at the wall or disconnect from the mains supply.
4.6

Hot Bowl Flag

®
If a SmartDrive machine has been filled with hot water and has not had a cold rinse, it will not spin
up to its full speed of 1000 RPM. Its maximum speed will instead be restricted to a maximum of
700 RPM. This is to prevent distortion of any internal plastic componentry that may occur at a high
spin speed.
The hot bowl flag works the same for the GW as it does for the MW, however as the MW does not
have as many LEDs as the GW, the hot bowl flag is not visible unless a GW display is fitted.
To check to see if this flag has been enacted, firstly enter diagnostic mode (Refer to Section 4).
The LED adjacent to WATER SAVER will be lit.
To clear this flag and allow SmartDrive
GW Washer: Either press the OPTIONS button while in diagnostic mode, or put SmartDrive
through a complete final rinse.
MW Washer: Put SmartDrive
clear through diagnostics as described above.
4.7

Data Download

Enter diagnostic mode. Press START/PAUSE. The Lid Lock LED will now be on and flickering.
Place the download pen over this LED and follow the instructions supplied with the data download
programme.
4.8

User Warnings

There are a number of warnings which are generally caused by the user or poor installation.
These warnings should be able to be corrected by the user. SmartDrive
flashing LEDs and a rippling set of 5 beeps repeated every 6 seconds. This is the same tone that
is heard when SmartDrive
Most of this information is available to the user in the 'Use and Care Manual'.
®
to spin to 1000RPM:
®
through a complete final rinse or plug in a GW display module and
®
is first plugged into the mains power.
26
®
signals user warnings by
®