Diagnostics; Service Mode - Fisher & Paykel AWF60MD Manual

Remove the tabletop.

Start the test program.

Place a clamp-on amp meter around either Grey or Red wire going to the

element.
The heater will activate when the test program reaches Step 6.
The current draw will be approximately 8.5 amps.

Diagnostics

If a fault occurs in the product one of four LED's will start flashing. To
determine the cause of the LED flashing follow the procedures as listed
below.
Prewash LED flashing
Main Wash LED flashing
Rinse LED flashing
Conditioner LED flashing

Service Mode

To enter Service Mode follow the steps below.
(a). Ensure that the power to the machine is switched on.
(b). Press the On/Off button to switch the machine on (wait 5 seconds until
the display turns on).
(c). Press and hold Prewash & Extra Rinse down for 2 seconds.
(d). If a fault code is present it will be displayed in the LED screen.
(e). If a fault code is present refer to section on fault codes.
This fault relates directly to the
control module and it will require
replacement.
The most likely cause of the Main
Wash LED flashing is due to a
component
To rectify this fault refer to the
flowchart "No Water"
To rectify this fault refer to the flow
chart "Unable to select a program"
9