Xerox LF8140.8145 User Manual page 126

Error Messages on the Transmission Re-
EN port
Non programmed number
Disconnected
Can't communicate
Subscriber has stopped
Check called number
Transmission failed
Voice contact
126 ¦ Service · Error Messages and Possible Causes
Possible Cause(s)
The recipient's number is no longer stored in
the device. This can occur, for example, if you
have selected the telephone book entry as a
recipient for a fax message which should be
sent at a later time and delete the telephone
book entry before the time of transmission.
The transmission process was interrupted.
Repeat the transmission process.
Call the number and check whether the
number is a fax number and whether the
connected fax device is ready to receive
(whistling tone or silence). Press FAX or o
to send the message manually.
Ask the recipient whether the device is ready
to receive.
Repeat the transmission process with a lower
transmission speed (see also chapter
ing Transmission Speed
, page 89).
Fax Transmission: Repeat the transmission
process.
Call the number and check whether the
number is a fax number and whether the
connected fax device is ready to receive
(whistling tone or silence). Press FAX or o
to send the message manually.
Ask the recipient whether the device is ready
to receive.
Fax Reception: Fax reception was interrupt-
ed. Ask the sender to send the fax message
again.
Call the number and check whether the
number is a fax number and whether the
connected fax device is ready to receive
(whistling tone or silence). Press FAX or o
to send the message manually.
Reduc-