Anti-Tip Device Installation; Wall Mount Anti-Tip Installation; Floor Mount Anti-Tip Installation - Viking D3 Installation Manual

Leveling/Adjustments/Alignments
7
Set the high corner of range so that the top of side trim is
3/8" (0.95 cm) above countertop. Level range to high corner.

Anti-tip Device Installation

WARNING
TIPPING HAZARD
• THIS RANGE CAN TIP.
• A CHILD OR ADULT CAN TIP
THE RANGE AND BE KILLED.
• FAILURE TO INSTALL THE
ANTI-TIP DEVICE CAN
RESULT IN DEATH OR
SERIOUS BURNS TO
CHILDREN OR ADULTS.
• IF THE RANGE IS MOVED THEN THE
ANTI-TIP DEVICE MUST BE
RE-ENGAGED.
Your range is shipped
standard with two types of
anti-tip devices.
Type 1 is a wall mount device
which can be used for all
installation applications.
Type 2 is a floor mount device
which can be used for all
applications other than when
the range is installed on a concrete sub-floor.
Important: The range MUST be installed
with one of the anti-tip devices.
20
(cont.)
WARNING
TIPPING HAZARD
To reduce the risk of the
appliance tipping, it must be
secured by a properly installed
anti-tip bracket(s). To make sure
the bracket has been installed
properly, look behind the range
with a flashlight to verify proper
installation engaged in the rear
top left corner of the range or under the range
to verify that a floor hook and bracket have
been installed.

Wall Mount Anti-tip Installation

1
M e
a s
u r e
m e
n t
( A
)
Measure from floor to bottom
of the anit-tip opening located on the back of range.
This will be measurement (A).
Wall Mount Anti-tip Installation
2
3 - 5 3 - 5 3 - 5
/ 8 / 8 / 8
( 9 . ( 9 . ( 9 .
" " "
2 c 2 c 2 c
m ) m ) m )
m ) m ) m )
) ) )
( A ( A ( A 3 c 3 c 3 c
( 1 . ( 1 . ( 1 .
/ 2 " / 2 " / 2 "
+ 1 + 1 + 1
Locate anti-tip bracket on rear wall with the top left corner at
measurement (A) plus 1/2" (1.3 cm) from the floor and 3-5/8" (9.2 cm)
from where the right side of range (facing range) is to be located.
4
Attach bracket with
mounting hardware provided.

Floor Mount Anti-tip Installation

1
8 - 1 8 - 1 8 - 1
/ 2 / 2 / 2
( 2 1 ( 2 1 ( 2 1
" " "
. 6 . 6 . 6
c m c m c m
) ) )
Ø Ø Ø
1 / 1 / 1 /
8 " 8 " 8 "
( . 3 ( . 3 ( . 3
2 c 2 c 2 c
m ) m ) m )
Locate anti-tip bracket hook on the floor 8-1/2" (21.6 cm) from side
cabinet and 1-1/2" (3.8 cm) from rear wall. Mark and
drill 1/8" (.32 cm) holes where bracket will be located.
21
(cont.)
3
Mark and drill holes where bracket will be located.
2
1
1
Mount anti-tip bracket hook to floor
using screws provided.