Anti-Tip Device Installation; Wall Mount Anti-Tip Installation - Viking RVER Installation Manual

Electric 30” range 3 series
Table of Contents

Advertisement

Leveling/Adjustments/Alignment
7
Set the high corner of range so that the top of side trim is
3/8" (0.95 cm) above countertop. Level range to high corner.

Anti-tip Device Installation

WARNING
TIPPING HAZARD
• THIS RANGE CAN TIP.
• A CHILD OR ADULT CAN TIP
THE RANGE AND BE KILLED.
• FAILURE TO INSTALL THE
ANTI-TIP DEVICE CAN
RESULT IN DEATH OR
SERIOUS BURNS TO
CHILDREN OR ADULTS.
• IF THE RANGE IS MOVED THEN THE
ANTI-TIP DEVICE MUST BE
RE-ENGAGED.
Your range is shipped standard with two
types of anti-tip devices.
Type 1 is a wall mount device
which can be used for all
installation applications.
Type 2 is a floor mount
device which can be used for
all applications other than
when the range is installed
on a concrete sub-floor.
Important – The range MUST be installed
with one of the anti-tip devices.
(cont.)
WARNING
TIPPING HAZARD
To reduce the risk of the
appliance tipping, it must be
secured by a properly installed
anti-tip bracket(s). To make sure
the bracket has been installed
properly, look behind the range
with a flashlight to verify proper
installation engaged in the rear
top left corner of the range or under the range
to verify that a floor hook and bracket have
been installed.

Wall Mount Anti-tip Installation

1
Measure from floor to bottom
of the anit-tip opening located on the back of range.
This will be measurement (A).
20
( A
( A
)
)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Crver

Table of Contents