Searching An Input Signal; Selecting An Aspect Ratio - Hitachi CP-D27WN User Manual

Operating

Searching an input signal

1.
Press SEARCH button on the remote control.
The projector will start to check its input ports as below in
order to  nd any input signals.
When an input is detected, the projector will stop searching
and display the image. If no signal is found, the projector will
return to the state selected before the operation.
COMPUTER IN1
VIDEO
S-VIDEO
HDMI
● While ON is selected for AUTO SEARCH item in OPTION menu (
projector will keep checking the ports in the above order repeatedly till an
input signal is detected.
● It may take several seconds to project the images from the USB TYPE B port.

Selecting an aspect ratio

1.
Press ASPECT button on the remote control.
Each time you press the button, the projector switches the
mode for aspect ratio in turn.
For a computer signal
NORMAL
For an HDMI
NORMAL
For a video signal, s-video signal or component video signal
4:3 16:9
For an input signal from the LAN, USB TYPE A or USB TYPE B port, or
if there is no signal
CP-D27WN/CP-D32WN: 4:3 ( xed)
CP-DW25WN: 16:10 ( xed)
● ASPECT button does not work when no proper signal is inputted.
● NORMAL mode keeps the original aspect ratio setting.
● The on-screen menu might be displayed outside of the image display area
depending on the adjustment value of the ASPECT, D-ZOOM and
KEYSTONE. Changing the values of ASPECT, D-ZOOM and
KEYSTONE may  x the symptom.
COMPUTER IN2
USB TYPE B
4:3 16:9 16:10
TM
signal
4:3 16:9 16:10
16:10 14:9
LAN
USB TYPE A
NATIVE
14:9 NATIVE
NATIVE
SEARCH button
VIDEO COMPUTER MY SOURCE/
DOC.CAMERA
ASPECT AUTO
SEARCH BLANK
MAGNIFY FREEZE PAGE VOLUME
UP
ON
DOWN
OFF
MY BUTTON
KEYSTONE 1 2 MUTE
56), the
ASPECT button
VIDEO COMPUTER MY SOURCE/
DOC.CAMERA
ASPECT AUTO
SEARCH BLANK
MAGNIFY FREEZE PAGE VOLUME
UP
ON
DOWN
OFF
MY BUTTON
KEYSTONE 1 2 MUTE
23