Using The Magnify Feature - Hitachi CP-D27WN User Manual

Operating

Using the magnify feature

1.
Press the MAGNIFY ON button on the remote control.
The picture will be magni ed, and the MAGNIFY dialog will
appear on the screen. When the MAGNIFY ON button is
pressed for the  rst time after the projector is turned on, the
picture will be zoomed by 1.5 times. On the dialog, triangle
marks to show each direction will be displayed.
2.
The display magni cation of the projector switches in order
with every press of the MAGNIFY ON button.
For computer signals, HDMI
LAN, USB TYPE A or USB TYPE B port
1.5 times
For video signals, s-video signals, component video signals or HDMI
(Component) signals
1.5 times
3.
While the triangles are displayed on the dialog, use the ▲/▼/◄/► cursor
buttons to shift the magnifying area.
4.
Press the MAGNIFY OFF button on the remote control to exit magni cation.
● The MAGNIFY dialog will automatically disappear in several seconds with no
operation. The dialog will appear again if the MAGNIFY ON button is pressed
when the dialog has automatically disappeared.
● The magni cation is automatically disabled when the displaying signal or its
display condition is changed.
● While the magni cation is active, the keystone distortion condition may vary.
It will be restored when the magni cation is disabled.
● Some horizontal stripes might be visible on the image while magni cation is
active.
● This function is not available in the following cases:
- A sync signal in the range not supported is input.
- There is no input signal.
TM
2 times 3 times
2 times 1 time
(RGB) signals, input signals from the
4 times 1 time
MAGNIFY
ON/OFF button
VIDEO COMPUTER MY SOURCE/
DOC.CAMERA
ASPECT AUTO SEARCH BLANK
MAGNIFY FREEZE PAGE VOLUME
UP
ON
OFF DOWN
MY BUTTON
KEYSTONE 1 2 MUTE
TM
27