Power On/Off; Turning On The Power - Hitachi CP-D27WN User Manual

Power on/off

Power on/off

Turning on the power

1.
Make sure that the power cord is rmly
and correctly connected to the projector
and the outlet.
2.
Make sure that the POWER indicator is
steady orange (
lens cover.
3. Press the STANDBY/ON button on the
projector or the remote control. The
projection lamp will light up and the
POWER indicator will begin blinking in
green. When the power is completely on,
the indicator will stop blinking and light in
steady green (
To display the picture, select an input signal according to the section Selecting an
21).
input signal (
The INITIAL SETTING Menu will be displayed by factory default upon startup.
Once the INITIAL SETTING Menu is set, it will not appear until FACTORY RESET
66) is executed. If you wish to change the settings, refer to the LANGUAGE
(
50) and ALTITUDE (
(
(1) LANGUAGE: Use the ▲/▼/◄/►
buttons to select the desired language
and press the ENTER button of the
remote control or the INPUT button of
the projector to execute.
(2) ALTITUDE: Use the ▲/▼ buttons to
select NORMAL for altitude below
1600 m (5250 feet), otherwise select
HIGH and press the ENTER button of
the remote control or the INPUT button
of the projector to execute.
(continued on next page)
110). Then, remove the
110).
60) menu.
STANDBY/ON button
POWER indicator
19