Buffalo WAPS-APG600H User Manual page 32

Chapter 3 Configuration
Parameter
AOSS Clients
Notes: · When AOSS or WPS is initiated, all other operations are disabled until the setup process is complete.
· If AOSS or WPS is not able to complete setup after three minutes, setup is cancelled and the AirStation
returns to normal operation.
· Up to 24 wireless devices can be connected with AOSS. Settings configured by AOSS can't be modified.
To change the settings, either run AOSS again or disable AOSS and configure settings manually.
· The AOSS function is disabled in the default settings.
· To connect a non-AOSS device to a network configured with AOSS, enter the SSID and key in the
device's settings manually.
· If SSID 1 is configured, its settings will be used by AOSS configuration. The following security settings
will not be used however:
WPA2-PSK AES
WPA2-PSK TKIP
WPA2-PSK TKIP/AES mixed mode
· AOSS can't be used if the SSID 1 encryption key contains spaces or 64 hexadecimal characters.
Meaning
SSID
This is the SSID corresponding to each encryption level.
Only the SSID for the currently-set encryption level is used.
Encryption Key
This is the currently-available encryption key.
This displays information about the wireless devices connected by
AOSS.
Client Information
These are the names of the wireless devices connected by AOSS.
MAC Address
These are the MAC addresses of the connected wireless devices.
Supported Encryption
This displays all the encryption levels corresponding to the wireless
devices connected by AOSS.
- 31 -