Recommended Grounding Method - Heath Zenith 4395 Installation And Operating Instructions Manual

WIRING
WARNING: Turn power off at circuit breaker
or fuse.
Note: All wiring must be run in accordance with the
National Electrical Code through conduit or another ac-
ceptable means. Contact a qualified electrician if there is
any question as to the suitability of the system.
CAUTION: DO NOT connect the RED wire unless
you want to control other lights from the motion
sensor (see Optional Wiring).
Black
Green or
Bare
White
One Motion Light
Black
Green or
Bare
White
Two Motion Lights
204069-01
Connect the fixture wires to the wires in the junction
box. Twist the wires together and secure with wire con-
nectors.

Recommended Grounding Method

Use a green ground "pigtail" (not provided) and twist
one end together with the bare fixture wire and the
box ground wire. Secure with a wire connector. Secure
the other end of the "pigtail" with the GND screw on
the X-bar.
Black to black
White to white
If you have metal junction box, you may not need the green
"pigtail". If you are unsure about the grounding method,
consult your local building code.
3