Installation
RIGHT REAR
(4)
(5)
(6)
(4) lug
(5) slot
(6) swingarm
1.
Reverse the removal procedure. Make sure
the lug ( ) on the brake caliper is located in
4
the slot ( ) in the swing arm ( ). Check that
5
the chain adjusters are installed properly.
2.
3.
4.
If a torque wrench was not used to install the
wheel, see your Honda dealer as soon as
possible to verify proper assembly. Improper
assembly may lead to loss of braking capacity.
6
Torque the axle nut to:
65 lbf·ft (88 N·m , 9.0 kgf·m)
Adjust the drive chain (page
Apply the rear brake, release it, then spin the
wheel and check that it rotates freely. Repeat
this procedure several times.
Servicing Your Honda
Wheels
126
).
117