Sony DSR-50P Operating Instructions Manual page 89

Submenu
Icon/Menu
(page)
AUDIO SET LIMITER
A
WIND
(page 21 (GB))
LCD SET menu
Submenu
Icon/Menu
(page)
LCD SET LCD BRIGHT Adjusts the LCD monitor brightness. Rotate and press the SEL/PUSH EXEC dial to adjust
LCD
LCD COLOR
(for DSR-50) /
LCD COLOUR
(for DSR-50P)
Setting
Turns the limiter on/off.
OFF : No limiter
ON: Uses the limiter.
Notes
• This setting is disabled when inputting signals from the DV IN/OUT connector.
• This setting is available only when you have set the AUDIO SELECT switches on the front
panel to MANU.
• Make sure to set the audio input level control selectors on the right panel correctly. Even if
you have set this item to ON, the limiter will not work for a sound that exceeds the dynamic
range of the input amplifier.
Enables/disables the wind noise reduction function for microphones.
You can set the wind noise reduction for audio channels 1 to 4 separately. If you select this
item, the channel to which the noise reduction is currently applied is displayed. (Example: If
noise reduction is applied to channels 1 and 3, "CH1,3" is displayed. If all channels are set
to OFF, "OFF" is displayed.)
OFF : No wind noise reduction
ON: Wind noise reduction
If you press the SEL/PUSH EXEC dial, the channel names are displayed. Select the
channel to be changed, change the setting, then press the SEL/PUSH EXEC dial.
Note
This setting is disabled when inputting signals from the DV IN/OUT connector.
Setting
and set the brightness. You can also adjust the brightness by rotating the SEL/PUSH EXEC
dial on the TC screen. (The triangle under the bar is displayed in green when the setting is
set to the factory preset value.)
Adjusts the depth of color of the LCD monitor. Rotate and press the SEL/PUSH EXEC dial
to adjust and set the depth of color. (The triangle under the bar is displayed in green when
the setting is set to the factory preset value.)
Chapter 6 Adjusting and Setting Through Menus
89
(GB)