Sony DSR-50P Operating Instructions Manual page 39

To video equipment without a DV jack (when using the DSR-50/50P as a player)
Monitor
Reference signal
generator
SG
to the
B.B.OUT
to the
connector
B.B.OUT
connector
75 Ω coaxial cable
(not supplied)
You can connect this unit to video equipment without a DV jack. Use this
unit as a player as follows.
The following shows an example configuration of dubbing a tape with its
time code in the externally-synchronized playback mode. In this
configuration, the recorder is a VCR equipped with component input
connectors.
to the audio input
jack
to the video input
connector
75 Ω coaxial cable
(not supplied)
Phono jack cable (not
supplied)
to the REF.VIDEO
connector
recorder
to the time code
input connector
to the
to the
75 Ω coaxial cable
component input
audio
(not supplied)
connectors
input
connectors
Video cable (3BNC y 3BNC) (not supplied)
Conversion cable (XLR y phono) (not supplied)
Amplifier (as needed)
Notes
• If you connect the input connectors of this VCR to the output connectors
of the monitor or recorder, a humming noise may be generated or the
image may be distorted.
• Text data (time code, warnings, menus, etc.) are superimposed only on
the signal sent to the VIDEO OUT1 output.
• To play back synchronized with the reference video (black burst) signal,
set the EXT SYNC on the VIDEO SET menu to ON.
75 Ω coaxial cable (not supplied)
DSR-50/50P (player) (right panel)
: Signal flow
Chapter 2 Preparations
39
(GB)