Terminal Adapter - Bosch Integral TM13 Operating Instructions Manual

Terminal adapter

You can use the built-in terminal adapter to set up data connections to compatible
data terminals via the V.24 interface. You must first define the transmission parame-
ters. You can also make calls simultaneously depending on the connection to your
telephone system.
Setting up data connections
Menu
TA 1234
Menu
You can set up a data connection manually
from the keypad of your telephone or by
means of data terminal dialing.
Set up via your phone:
Select the menu item "TA dialing". You can
'TA dialingµ
use this function to set up a data connec-
tion via the keypad on your telephone.
You may now enter the call number of your
communication partner.
Enter the desired number. If you wish to
store the data transmission numbers under
destination keys, you must define these
numbers as "Data destinations" in the tele-
phone book (
Select the menu item "Dial". The call num-
ber is dialed and you can begin data trans-
mission.
Making normal calls in between:
Select the menu item "TA dialing".
'TA dialingµ
This allows you to alternately display in-
formation about your call or data connec-
tion.
Note:
The display message "on" indicates that
the data connection exists. If you store the
"TA dialing" function on a function key, you
can switch the call mode by means of a
single keystroke.
Setup via your data terminal:
You can set up a data connection via your
data terminal. Specify the corresponding
dialing method. Further information may be
found in the user manual of the terminal
adapter.
If in doubt, look it up
p. 60).
-
137