Ironman Fitness LEGACY Owner's Manual page 9

Assembly
9. If Safety Latch Assembly will not secure
correctly, turn the four Screws counter-
clockwise a half turn.
NOTE: DO NOT REMOVE SCREWS FROM
LATCH HOUSING.
Next, slide the Safety Latch Housing up
or down to align the Safety Latch with
center of hole located on the left handle-
bar. Tighten the four Screws to secure the
assembly in place.
10. Install the Left and Right Fenders to
Base using Philip Screw ST4.2X16 as shown
in Figure 8.
11. Assembly is complete. Move Treadmill
to permanent location. See Moving
Instructions. Before operating the tread-
mill, adjust Levelers so that Base of tread-
mill does not wobble. See Figure 9.
Note: Leveler is found underneath tread-
mill.
You have completed the assembly of your new Ironman LEGACY Treadmill!
SCREWS
Figure : Safety Latch Adjustment
BASE
LEFT FENDER
Figure 8: Left and Right Fender Installation
Congratulations!
9
PHILIP SCREW
ST4.2x16
Figure 9: Adjust Levelers
LATCH HOUSING
RIGHT FENDER