Ironman Fitness LEGACY Owner's Manual page 6

Assembly
Assembly requires the included Allen wrench and Phillips screwdriver.
Do not plug in the power cord until all assembly steps are completed.
1. Leave the unit on the original
packing material to assemble all
parts.
RIGHT UPRIGHT
2. Connect the console harness
together. One side of harness is
LEFT UPRIGHT
located near the motor cover on
the bottom left side. The other end
is located inside the Left Upright
SPRING WASHER 8 mm
assembly. See Figure 1 and 2. Pull
the wiring harness from top of
upright tube making sure harness
connectors are pulled into large
WASHER 9*16*1.6MM
hole at bottom of upright.
ALLEN BOLT
3. Install the Left and Right
ALLEN BOLT 5/16" - 18x70
5/16" - 18x15
Uprights to the treadmill base
frame by inserting the upright con-
necting bracket into base frame as
seen in Figure 1, using Allen Bolt
5/16"-18 x 70 (Qty. 2), Spring
Washer 8 mm (Qty. 4), and Washer
9*16*1.6 mm (Qty. 4).
Next, install the Allen Bolt 5/16"-18
x 15 (Qty. 6), Spring Washer 8 mm
(Qty. 6), and Washer 9*16*1.6 mm
(Qty. 6). Refer to Figure 3.
Note: Do not tighten hardware in
step 4 until step 7 is completed.
Ensure that the Allen Bolt 5/16"-
18 x 70 is placed in the upper hole
on the upright and the Allen Bolt
Figure 1: Console Harness Location
5/16"-18 x 15 is placed on the
lower whole of the upright.
Caution:
Make sure harness is installed inside the upright and pay attention not to pinch the
wire harness.
Figure : Console Harness Connection
6